Difficulty
Very easy
Steps
6
Time Required
00:20:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Hello, this valve was making a lot of noise. Even if it did not cause engine failure, I preferred to change it preventively.
Steps for replacing the turbocharger control valve on the 1.6 tdci engine
Tools
Parts
-
-
Hello, this valve was making a lot of noise. Even if it did not cause engine failure, I preferred to change it preventively.
-
Turn off the vehicle's ignition.
-
-
-
The valve is located on the driver's side in the engine compartment. Behind the headlight unit.
-
-
-
Remove the two 10 nuts
-
Disconnect the electrical outlet. photo 2
-
Locate the connection of the two air hoses and disconnect them.
-
-
-
Reconnect the two air hoses in the correct direction.
-
Reconnect the electrical outlet
-
Replace and tighten the two 10 nuts.
-
-
-
Check that the hoses are properly connected and routed. Be careful that they are not stuck in one place to avoid a breakdown or premature wear.
-
