Introduction
Replacing a tail light bulb.
Parts
-
-
Inside the trunk, a small plastic cover hides access to the screw that holds the rear light.
-
Remove the plastic cover with a screwdriver (lever).
-
-
-
Use a flat screwdriver (or a 13 socket) and unscrew the light attachment (counterclockwise).
-
Attachment removed
-
-
-
Use lever on the left side of the light to release the two lugs behind the light (yellow circle).
-
To disconnect the harness, insert a small screwdriver into the connector and pry up while pulling on the connector.
-
-
-
Pull the plastic clips outwards to remove the bulb holder.
-
Remove the defective bulb and replace it with a new light bulb
-
-
-
Check that the seal is in its correct location before reassembling the support (important to prevent water from entering the light).
-
Replace the plastic holder with the bulbs in the clips.
-
Reconnect the connector.
-
-
-
Start by inserting the screw into the hole
-
Push the fire in the spurs (left side).
-
Turn on the ignition and test the bulb.
-
Screw the fastener of the tail lights and replace the plastic cover.
-
Cancel: I did not complete this guide.
5 other people completed this guide.
2 Comments
I am looking for a video to change the brake lights on my Audi A3 year 1999
Stephan Personne - Resolved on Release Reply
Good morning,
Please note that for step 2, where you have to remove the plastic clip from the light, it is better to use a 13 socket rather than a screwdriver.
Alexandre Roussel - Resolved on Release Reply
