Difficulty
Easy
Steps
4
Time Required
00:30:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
The model presented is a Ford Ka phase 1 1.3 i 60cv.
The operation must be carried out with the engine cold.
Parts
-
-
Open the hood
-
4 cylinders therefore 4 spark plugs
-
-
-
Remove the ignition cable that is connected to the spark plug by pulling on it and then pulling it away.
-
Using your wrench, unscrew the spark plug and remove it.
-
Old candle
-
New spark plug
-
Place the new spark plug into the well and tighten it.
-
Replace the ignition cable.
-
Proceed candle by candle because if you disconnect all the cables at the same time you may not remember where they are.
-
Cancel: I did not complete this guide.
One other person completed this guide.
3 Comments
Hello and to change the spark plug wires there is no post please
MATHIEU LEYGNAC - Resolved on Release Reply
As indicated on the product sheet of the spark plug on Oscaro.com the torque is 20Nm
laurent.immo13003 - Resolved on Release Reply
What tightening torque? please thank you
patrick schneider - Resolved on Release Reply
