Changing the rear light bulb on a Peugeot Partner

For changing a bulb in your tail light on Peugeot Partner, you will need unscrew the two screws who are located and who maintain the fire.

For that, use a screwdriver with a TORX 30 bit and remove the screws completely.

You can then, pull gently towards you to unclip the rear light, it holds with 1 clip in the middle only.

Now you can see that this one holds with a connector plugged into it, remove it by pinching the top and pulling hard.

You have now the tail light in your hands, it will be necessary Carefully unclip the rear plate by pushing the 4 clips present on the fire and pulling outwards.

You can now "change the bulb you want", to do this turn the bulb by pressing gently on it.

In red: Feu stop/position.

In orange: Cligotant.

In blue: Reversing light.

In purple: Anti-Fog.

Now do the steps in reverse order to be able to put the plate back in its housing, connect the light connector then reclip, screw the rear light back in with your TORX 30 bit screwdriver.