Introduction
Here we are going to replace the pressure sensor, on Ford Fiesta IV 1.3 Petrol, this sensor is located on the air intake manifold.
Tools
Parts
-
-
The pressure sensor is located on the air intake manifold towards the rear of the engine compartment.
-
-
-
Disconnect the sensor connector, to do this press the tab then pull the connector.
-
It is advisable to wait until the engine has cooled and to wear gloves when removing the sensor.
-
Unscrew the screw, which holds the sensor on the intake manifold, using a Torx T25 screwdriver.
-
Remove the sensor by pulling on it.
-
-
-
Check that the new sensor matches the old one both in terms of its attachment and the connector.
-
The pressure sensor is a sensitive part so avoid any shock when handling it.
-
-
-
Position the sensor on the collector and press hard enough to insert it properly.
-
Replace the Torx screw, being careful not to drop it, and tighten it.
-
Reconnect the connector, making sure to clip it securely.
-