Skip to main content

Introduction

Vehicle engine 1.9 D 70cv

  1. 
The fuel filter is located in a housing in the center of the engine compartment.

To remove the filter, it is necessary to open the housing cover.

Use an Allen key to unscrew the 4 screws.
    • The fuel filter is located in a housing in the center of the engine compartment.

    • To remove the filter, it is necessary to open the housing cover.

    • Use an Allen key to unscrew the 4 screws.

    • Place a cloth around the box to absorb any diesel that may leak.

  2. 
Wedge the cover on the left without disconnecting the hose.

Remove the fuel filter from its housing. Let the diesel still present in the filter flow out.

Check the cleanliness of the case.
    • Wedge the cover on the left without disconnecting the hose.

    • Remove the fuel filter from its housing. Let the diesel still present in the filter flow out.

    • Check the cleanliness of the case.

  3. 
Compare the new fuel filter and the old one

Place the new filter back in its housing. Check the direction carefully, the seal is at the top.

The filter must be well centered and its seal must be positioned flush with the housing
    • Compare the new fuel filter and the old one

    • Place the new filter back in its housing. Check the direction carefully, the seal is at the top.

    • The filter must be well centered and its seal must be positioned flush with the housing

  4. 
Replace the cover on the case, aligning the notch correctly to center it.

Replace 2 screws in opposite corners and hand tighten.

Finish by placing the other 2 screws and tighten crosswise with the Allen key.
    • Replace the cover on the case, aligning the notch correctly to center it.

    • Replace 2 screws in opposite corners and hand tighten.

    • Finish by placing the other 2 screws and tighten crosswise with the Allen key.

  5. 
Remove the cloth and clean around if necessary.

To re-prime the fuel circuit it is necessary to use the pump on the opposite side.

Squeeze the pump by hand several times until it stiffens.
    • Remove the cloth and clean around if necessary.

    • To re-prime the fuel circuit it is necessary to use the pump on the opposite side.

    • Squeeze the pump by hand several times until it stiffens.

    • Turn the ignition on, wait a few seconds and start the engine. If it doesn't start, pump a few more times.

    • Check that the housing is working properly and is watertight.

Finish Line

6 other people completed this guide.

hemissi-nizar

Member since: 01/16/2017

21,057 Reputation

88 Guides authored

2 Comments

v,hyinbv,g,v,; ,vnbxdhwjkg

cpaquereau27 - Reply

super facile a faire

cpaquereau27 - Reply

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 24

Past 30 Days: 130

All Time: 10,831