Skip to main content

Introduction

Vehicle engine 1.4 HDi 70 hp

  1. 
The fuel filter is attached to the left side of the engine.

Remove the covers from la batterie

Remove the cover on the engine.
    • The fuel filter is attached to the left side of the engine.

    • Remove the covers from la batterie

    • Remove the cover on the engine.

    • Remove the air intake cover.

    • Remove the air filter cover mounting screws using a T20 torx screwdriver.

  2. 
Remove the air duct fixing screw, then disconnect it and separate the 2 ducts.

Remove the fixing screw Torx T20 from the vacuum pipe flange, on the filter housing, then move it aside.

Remove the fixing screw Torx T20 from the vacuum pipe flange, on the filter housing, then move it aside.
    • Remove the air duct fixing screw, then disconnect it and separate the 2 ducts.

    • Remove the fixing screw Torx T20 from the vacuum pipe flange, on the filter housing, then move it aside.

  3. 
Remove the housing fixing screw, torx T20.

Disconnect the supply and return lines, pinching their white tab to unlock them.

Allow the fuel to flow by sealing the pipes using the plug supplied with the new filter. And a cloth under the filter.
    • Remove the housing fixing screw, torx T20.

    • Disconnect the supply and return lines, pinching their white tab to unlock them.

    • Allow the fuel to flow by sealing the pipes using the plug supplied with the new filter. And a cloth under the filter.

  4. 
Release the box from its support by pivoting it, counterclockwise, around its rear anchor point.

Pull the housing upwards to carefully release it, then disconnect the electric heater connector located under the filter.

Check that le nouveau filtre à carburant corresponds to the old one.
    • Release the box from its support by pivoting it, counterclockwise, around its rear anchor point.

    • Pull the housing upwards to carefully release it, then disconnect the electric heater connector located under the filter.

    • Check that le nouveau filtre à carburant corresponds to the old one.

  5. 
Proceed to reinstall the box correctly on its support, as well as the screws. Then connect the pipes.

The pump to re-prime the fuel circuit is located on the other side of the air filter.

To purge the air, press the primer bulb with your hand until you feel resistance.
    • Proceed to reinstall the box correctly on its support, as well as the screws. Then connect the pipes.

    • The pump to re-prime the fuel circuit is located on the other side of the air filter.

    • To purge the air, press the primer bulb with your hand until you feel resistance.

    • Check the circuit for leaks and replace the covers.

Finish Line

8 other people completed this guide.

hemissi-nizar

Member since: 1/16/17

21,087 Reputation

88 Guides authored

One Comment

Be careful, re-priming is very complicated after pumping for 2 minutes still nothing. Is there another way to re-prime or do I have to disconnect a power supply?

THANKS

yaguila - Resolved on Release Reply

Add Comment



View Statistics:

Past 24 Hours: 7

Past 7 Days: 37

Past 30 Days: 175

All Time: 16,923