Difficulty
Easy
Steps
6
Time Required
00:30:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
How to change a front fog light bulb on a Peugeot 307 phase 2 1.6 hdi
-
-
Remove the fixing clips with a small tournevis plat so that the attachment folds down so that it is easier to remove. There is also one next to the anchor point for lifting the car (be careful of the clips present next to the lifting point)
-
Remove the 2 aluminum clips (1/4 turn screw)
-
-
-
Remove the mudguard slightly
-
Carefully remove the mudguard
-
Pay attention to the ABS sensor mounting (a slot in the car body)
-
-
-
Access to l'ampoule de feux de brouillard
-
Unscrew counterclockwise
-
Extract from its location
-
Pull the small rod towards you while pulling the pin downwards without forcing too much so as not to damage it.
-
-
-
Push the new bulb back in until you hear a click.
-
Position it well between the slots of the plastic clips
-
-
-
Replace the wheel arch, paying attention to the ABS sensor
-
Tighten the wheel bolts Remove the jack and finish tightening the wheel crosswise with the vehicle on the ground
-
Cancel: I did not complete this guide.
7 other people completed this guide.
2 Comments
Just to clarify that this is on a 307 phase 2, because phase 1 had the front fog lights integrated into the headlights.
Sincerely
Thibault FOUIN - Resolved on Release Reply
