Difficulty
Moderate
Steps
9
Time Required
01:00:00
Private
This guide will not appear in search results and can only be viewed by team members!
Introduction
Vehicle engine 1.3 i-VTEC 16V 102 hp
-
-
Raise and chock the front of the vehicle. Remove the front wheels.
-
-
To access the brake pads you must remove the brake caliper
-
-
-
To remove the brake caliper, completely unscrew the lower fixing screw with a 13 mm and 17 mm wrench. And partially unscrew the upper screw to facilitate pivoting.
-
Lift the bottom of the caliper to pivot it around its upper mounting screw.
-
Hold it in place with bungee cords.
-
-
-
A retaining spring between the 2 plates. Pinch the ends and remove the .
-
-
-
Open the brake fluid reservoir cap in the engine compartment.
-
Use a piston pusher to be able to put the caliper on the new brake pads.
-
Don't forget to close the fuel cap.
-
-
-
Compare brake pad dimensions.
-
Use brake cleaner and a wire brush on the pad contact points.
-
-
-
Replace the retaining spring.
-
Replace the brake caliper and mounting screws with threadlocker.
-
-
-
Press the brake pedal repeatedly until it stiffens before driving the vehicle.
-
Read the pad break-in instructions in the manufacturer's instructions.
-
Cancel: I did not complete this guide.
One other person completed this guide.
