Skip to main content

Introduction

Vehicle engine 1.9 D 70cv

  1. 
The pressure switch is located above the oil filter

Use a flathead screwdriver to remove the clip holding the electrical connector

Use a flathead screwdriver to remove the clip holding the electrical connector
    • The pressure switch is located above the oil filter

    • Use a flathead screwdriver to remove the clip holding the electrical connector

  2. 
Disconnect the connector and place it to the side

If it is an internal leak from the pressure switch, oil visible in the plug, clean the switch

If it is an internal leak from the pressure switch, oil visible in the plug, clean the switch
    • Disconnect the connector and place it to the side

    • If it is an internal leak from the pressure switch, oil visible in the plug, clean the switch

  3. 
Using a 21 mm deep socket, remove the pressure switch.

Clean the seal area

Clean the seal area
    • Using a 21 mm deep socket, remove the pressure switch.

    • Clean the seal area

  4. 
Compare Engine Oil Pressure Switches

Put in place the copper gasket supplied with

Put in place the copper gasket supplied with
    • Compare Engine Oil Pressure Switches

    • Put in place the copper gasket supplied with

  5. 
Place the pressure switch in place and hand tighten until contact is made.

Tighten with the key

Reconnect the electrical connector and install the clip
    • Place the pressure switch in place and hand tighten until contact is made.

    • Tighten with the key

    • Reconnect the electrical connector and install the clip

Finish Line

One other person completed this guide.

hemissi-nizar

Member since: 01/16/2017

21,057 Reputation

88 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 10

All Time: 1,104