-
-
To make it easier to carry out your oil change, warm up your engine for at least 5 minutes. For better oil flow, you should then use un cric to lift your vehicle.
-
Place the jack in the designated location at the front of your vehicle on the passenger side, then raise your car to have space underneath, and for your security put one or two candle(s).
-
-
-
So that the oil flows easily and completely:
-
- Remove the rod used to see your oil level by pulling on it.
-
- Remove votre bouchon de remplissage of oil by unscrewing it.
-
-
-
Unscrew the cap using an 8 mm Allen key.
-
Position yourself under the car, put a baque or a basin For recover your oil Then below the engine you will see that a small screw is easily accessible, unscrew the until the oil flows out then retrieve the screw without dropping it in oil.
-
-
-
Allow the engine oil to drain completely until it no longer flows. -
Above all, do not leave your oil in nature, put it in a landfill that collects the oil so as not to pollute the planet.
-
-
-
You absolutely must changed the engine oil drain screw gasket, for that remove the old one by pulling on it then place a new gasket above.
-
-
-
Replace the previously cleaned cap, with a 14 mm diameter copper seal, using an 8 mm Allen key.
-
Place your screw in the place provided for the drain, start to tighten it by hand, then finish by tightening the screw firmly.
-
-
-
Please do the remplissage de votre huile in the engine oil filler compartment, pour 'about 4 liters of oil. Use 5w30 C2 or 5w40 C3 oil for low budgets. (Low ash content to preserve the FAP) Do not trust the photos, the author is using the wrong oil!!
-
For the 2l HDI, engine capacity after replacing the oil filter 5.25l. (Systematic filter replacement, during each oil change) Fill the engine with 5l of oil. You will be at 3/4 on the dipstick! This is more than enough.
-
- In red: Minimum oil level required. -
- In blue: Maximum oil level.
-
-
-
Before starting your engine: -
- Put back la jauge used to check the engine oil level.
-
- Replace the engine oil filler cap.
-
Cancel: I did not complete this guide.
6 other people completed this guide.
