Introduction
Replacement cabin filter Ford Focus II 1.6 TDCi 110cv
Tools
Parts
-
-
The cabin filter is located on the driver's side, near the accelerator pedal. -
With a key of 10 unscrew the 3 screws securing the accelerator pedal.
-
Without disconnecting the accelerator pedal connection.
-
-
-
Put the accelerator pedal to the side.
-
Using a 7 mm socket wrench, unscrew the 3 screws securing the cabin filter housing.
-
Extract the used filter element by deforming it to remove it from its housing; the same action should be considered for replacing the new filter.
-
Check the correspondence between the old and new filter
-
Reassembly is carried out in the reverse order of disassembly.
-
Frequency of change 1 time per year or every 15,000 kilometers
-
Cancel: I did not complete this guide.
11 other people completed this guide.
11 Comments
Shame on the people at Ford for creating such an access. It would have been simpler to at least put it on the passenger side...
Done. I didn't put the screw back on the top right... ouch ouch ouch back... be well equipped in articulated
difficult access, provide a ratchet key and a small wire to attach the accelerator pedal once removed (on the brake pedal) so that it does not get in the way during handling. Removal and replacement done in 20 minutes, but a real ordeal for the back.
health,
well I just finished changing the cabin filter of my Ford Focus, it's really difficult!!!! You mustn't have back pain because access is very limited, you have to lie with your head under the wheel. Work with good tools like a ratchet wrench and a tip: aim and unscrew the filter cover screw by hand, it comes off easily without using the ratchet because there's no room with the wrench. Good luck, allow a good hour of assembly and disassembly with a sore back to finish. My darling is going to have to give me a good massage.
