Introduction
This tutorial is made on a Renault Traffic II phase 2 2.0 dCi Combi 90cv
Tools
Parts
-
-
Pull the hood release flap located under the steering wheel to the left of the pedals to unlock the hood.
-
To open the hood, slide your fingers to the front middle under the hood and pull the tab of the opening mechanism towards you while lifting your hood.
-
-
-
Le filtre d'habitacle is located inside the box fixed under the hood. -
No tools are required to replace the filter, it is accessed through the opening at the bottom of the box.
-
-
-
To remove the old cabin filter, press the 2 fixing clips located on the side of the box.
-
Once unlocked, all you have to do is remove the filter from its location.
-
Use a blower to clean the box.
-
-
-
Check the correspondence between the new and the old cabin filter (reference, length, width, thickness, etc.)
-
-
-
Present the filter in front of you with the 2 plastic lugs on top.
-
The 2 tabs are facing you.
-
Fit the filter vertically into the box, the 2 lugs must fit correctly into the groove at the bottom of the box.
-
-
-
Push the bottom of the filter to snap it into place.
-
Once the 2 clips are engaged, the filter is correctly positioned.
-
Cancel: I did not complete this guide.
23 other people completed this guide.
10 Comments
Good morning,
I am looking to replace the cladding with the insulating foam that surrounds the box fixed under the hood but I cannot find this part even by typing the references written on it.
Any idea where I can find this?
THANKS
Arnaud Mélou - Resolved on Release Reply
