Changing the battery on a Peugeot 5008 2.0 HDi 150 Cv

Open the hood and access the engine

Remove the 2 screws from the brake fluid reservoir and place it to the side

Loosen the 4 screws on the air filter housing

Disconnect the cables, connector and mounting clamps

Disconnect the air supply and remove the upper part of the air filter

Lift the top part of the positive (+) terminal

Remove the fuse box cover

Remove the 2 nuts from the cables and disconnect the connector

Using a flat screwdriver, release the first retaining lug on the top of the block

Unlock the second retaining lug, then slide the block upwards

Place the fuse block to the side so it is not in the way.

Unclip the cable fixing (the fixing is quite flexible, it is possible to pass it under the cables from the side)

Remove the battery cover (you have to pull quite hard, the front upwards, then towards you)

Battery access is released

Disconnect the cables, the nut holding the battery and the negative terminal with a 10 wrench.

Remove the nut on the lower/left side of the battery

Remove the battery

Remove the old battery

Replace it with the new one

View of the new battery in place

Screw the fixing nut at the bottom left of the battery

Reconnect the wiring and tighten the negative terminal fixing nuts

Reposition the wiring and fixing in front of the battery

Replace the fastener

Replace the fuse block

Replace the connector

Screw the two nuts

Fix the battery cover

Industries la borne positive (+)

Replace the top part of the air filter and tighten the 4 screws

Connect the air inlet, connector, wiring and tighten the mounting clamp

Replace the brake fluid reservoir

Fix the two screws

END