Skip to main content

Introduction

Vehicle engine 1.6 HDi FAP 16V 110 hp

  1. 
Open the hood of the vehicle. The battery is located on the driver's side, in a protective box.

To access it, it is necessary to remove some plastic covers. Start with the air intake inlet protection.

To access it, it is necessary to remove some plastic covers. Start with the air intake inlet protection.
    • Open the hood of the vehicle. The battery is located on the driver's side, in a protective box.

    • To access it, it is necessary to remove some plastic covers. Start with the air intake inlet protection.

  2. 
The intake air duct is fixed to the chassis, use a 10mm wrench.

The intake air duct is fixed to the chassis, use a 10mm wrench.
    • The intake air duct is fixed to the chassis, use a 10mm wrench.

  3. 
Remove the intake air duct. Rotate the tube a quarter turn to unclip it and then remove it from its housing.

Remove the intake air duct. Rotate the tube a quarter turn to unclip it and then remove it from its housing.

Remove the intake air duct. Rotate the tube a quarter turn to unclip it and then remove it from its housing.
    • Remove the intake air duct. Rotate the tube a quarter turn to unclip it and then remove it from its housing.

  4. 
Lift the positive terminal cover.

Disconnect the positive terminal from the battery.

Disconnect the positive terminal from the battery.
    • Lift the positive terminal cover.

    • Disconnect the positive terminal from the battery.

  5. 
Lift the battery protection case from below to remove it.

Lift the battery protection case from below to remove it.
    • Lift the battery protection case from below to remove it.

  6. 
The battery is fixed to the chassis by means of a flange.

Use a 10mm socket to loosen the retaining screw.

Use a 10mm socket to loosen the retaining screw.
    • The battery is fixed to the chassis by means of a flange.

    • Use a 10mm socket to loosen the retaining screw.

  7. 
Disconnect the negative terminal from the battery.

Grasp the battery by the handle to remove it from its housing.

Grasp the battery by the handle to remove it from its housing.
    • Disconnect the negative terminal from the battery.

    • Grasp the battery by the handle to remove it from its housing.

  8. 
Compare batteries.
    • Compare batteries.

  9. 
Place the new battery in its location and check that it is seated properly.

Connect the negative terminal.

Connect the negative terminal.
    • Place the new battery in its location and check that it is seated properly.

    • Connect the negative terminal.

  10. 
Replace the flange and tighten the screw.

Replace the protective case.

Replace the protective case.
    • Replace the flange and tighten the screw.

    • Replace the protective case.

  11. 
Connect the positive terminal and wait 5 minutes before starting the vehicle.

Replace the intake air duct and protective cover.

Replace the intake air duct and protective cover.
    • Connect the positive terminal and wait 5 minutes before starting the vehicle.

    • Replace the intake air duct and protective cover.

Finish Line

7 other people completed this guide.

hemissi-nizar

Member since: 1/16/17

21,057 Reputation

88 Guides authored

3 Comments

How to remove the intake air duct, that's exactly the info I was looking for! :-)

Thank you so much.

François Lhioreau - Resolved on Release Reply

no need to remove the air line.

grendi salim - Resolved on Release Reply

au top, merci.

Sebastien Grousset - Resolved on Release Reply

Add Comment



View Statistics:

Past 24 Hours: 7

Past 7 Days: 51

Past 30 Days: 197

All Time: 40,170