Changing a light and/or a rear light bulb on a Dacia Logan

Inside the vehicle, unscrew the two plastic nuts that hold the light

then bring the fire towards you but do not pull too hard because everything is still connected

disconnect the plug from the light by pressing the tab and pulling

clean the body part

remove the foam seal

pinch the two retaining tabs

and pull the turntable up

stop light / position light

flashing

fog light for left tail light, reversing light for right tail light

Avoid touching the bulbs with your fingers. It is best to wear gloves to avoid leaving greasy marks on the glass.

press the bulb lightly

then turn 1/4 turn counterclockwise

and remove the bulb

Not all tail light bulbs are the same. Any defective bulb will be replaced with an absolutely identical bulb.

insert the bulb with its lugs in the housings of the plate

press lightly

and turn 1/4 turn clockwise

present the turntable on the fire

and press to engage the clips

put the foam seal in place

present fire

Connect the fire plug by pressing (you should hear a "click")

At this point you can check that all the bulbs are working.

To insert the light, you will have to align the lugs of the light with the locations in the bodywork

press the fire to set it in place

then while holding the fire down

screw the two plastic nuts