Difficulty
Very easy
Steps
6
Time Required
En cours
Ce tutoriel est en cours de création. Revenez de temps en temps pour voir les modifications.
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Work carried out on a Renault Twingo 2 phase 2, 1.5 dCi 75hp engine.
This is a car that I bought second-hand, I have neither a user manual nor a technical guide, so I don't know the capacities or the tightening torques.
-
-
Check that the airbag light comes on and goes off when you turn on the ignition.
-
Using a 10mm wrench, disconnect the battery.
-
-
-
Wait at least one minute after disconnecting the battery and deactivating the passenger airbag.
-
Using a 13mm long socket, remove the 2 nuts.
-
Using a flat screwdriver, lift the passenger airbag.
-
Leave the airbag as it is in the 3rd photo.
-
-
-
Using a flat screwdriver, remove the storage compartment.
-
-
-
Remove the cap by pulling on it.
-
Using a T20 Torx bit, remove the 2 screws to allow some clearance for the meter.
-
-
-
Old light bulb
-
New bulb
-
I bought BAx 8.5D/2 bulbs which fit very well even though they don't look identical.
-
Reassembly is carried out in reverse order.
-
Cancel: I did not complete this guide.
One other person completed this guide.
