Skip to main content

Tools

No tools specified.

  1. 
Remove the rubber cover by pulling the tab backwards

Remove the rubber cover by pulling the tab backwards
    • Remove the rubber cover by pulling the tab backwards

  2. 
Gently pull the connector straight back to disconnect it

Gently pull the connector straight back to disconnect it
    • Gently pull the connector straight back to disconnect it

  3. 
Unclip the bulb by applying light pressure to the top of the clip using a lateral movement.

Swing the clip all the way down to remove the bulb.

Compare the new bulb with the old one.
    • Unclip the bulb by applying light pressure to the top of the clip using a lateral movement.

    • Swing the clip all the way down to remove the bulb.

    • Compare the new bulb with the old one.

  4. 
Put the new bulb in place with the lug facing upwards

Put the clip back
    • Put the new bulb in place with the lug facing upwards

    • Put the clip back

    • Replace the electrical connector

  5. 
Replace the bulb cover
    • Replace the bulb cover

    • Turn on the headlight to check that it is working properly.

    Very bad subject title.

    The title is: changing the dipped beam headlight and the procedure is how to change a headlight! Zero, totally zero, no help.

    Thanks for the time wasted! No verification. Rightly complaining!

    Pip Konar - Reply

    Before you complain, read the title again… Pip Konar

    Nicolas Dajoux -

Finish Line

3 other people completed this guide.

Nicolas Dajoux

Member since: 09/13/2016

2,016 Reputation

8 Guides authored

7 Comments

Hello, I lost the rubber cover that protects against dust.

Under what reference can I find some?

Thank you!

mariek76 - Reply

Hello, I don't have a rubber cover.

pigachelionel - Reply

It helped me a lot, thank you!!!

plenitude91 - Reply

Hello and thank you very much for your help, best regards

Reda GOUMIDI - Reply

Hello, I am looking for someone to tell me how to remove a turn signal bulb on the front of the vehicle because it is very difficult to remove from the location on a Peugeot Partner Tepee. What should be removed? Thank you, it is clearly visible at the engine level...

Stéphane Vancauwelaert - Reply

Many thanks for this tutorial!

catherine dreanno - Reply

Very good tutorial. Thank you.

Too bad, though, that you don't specify where the low beam bulb is in relation to the high beam bulb. From the photo, it looks like it's the top one.

François Lhioreau - Reply

Add Comment

View Statistics:

Past 24 Hours: 13

Past 7 Days: 145

Past 30 Days: 661

All Time: 49,151