Introduction
It is necessary to disassemble the tail light to access and replace the bulbs.
-
-
To access the tail light we have to open the trunk.
-
Unscrew the 2 fixing screws of the light with a crosshead screwdriver.
-
-
-
You have to pull the tail light outwards to remove it.
-
2 lugs hold the light firmly in the body: 1 lug at the top and 1 lug at the bottom.
-
The easiest way is to use leverage. Use a unstapler tool plastic or a small flat screwdriver protected in a rag to avoid damaging the bodywork.
-
-
-
You can access all 3 media tail light bulbs.
-
Remove the power cables from the notches.
-
You have to unscrew each bulb holder 1/4 turn to remove it.
-
-
-
At this point you can replace the tail light with a new one, make sure it is the same model
-
The following steps show you how to reinstall the bulbs and reassemble your tail light.
-
-
-
To remove a bulb from its holder, you must press on it while turning it 1/4 turn.
-
Replace the defective bulb with a new one, checking its equivalence (model, power, etc.).
-
To replace the new bulb, push it into the holder and turn it until it stops.
-
-
-
Replace the holders with their new bulb in the light.
-
Turn the bracket 1/4 turn until it stops.
-
Replace the power cables in the slots.
-
-
-
Replace the tail light in its location.
-
Align the 2 lugs of the light in front of their housing in the bodywork.
-
Press to re-engage the tail light into its housing.
-
-
-
Replace the 2 rear light mounting screws.
-
Screw in the 2 screws with the crosshead screwdriver
-
You have replaced your bulbs and/or your tail light, this will avoid you being fined.
You have replaced your bulbs and/or your tail light, this will avoid you being fined.
Cancel: I did not complete this guide.
6 other people completed this guide.
