Skip to main content

Introduction

The model presented is a Renault Express phase 1.

  1. 
The silentbloc is on the stabilizer bar.

It is fixed by a bolt.

It is fixed by a bolt.
    • The silentbloc is on the stabilizer bar.

    • It is fixed by a bolt.

  2. 
Using 2 13mm wrenches remove the bolt.

Using 2 13mm wrenches remove the bolt.

Using 2 13mm wrenches remove the bolt.
    • Using 2 13mm wrenches remove the bolt.

  3. 
Raise the stabilizer bar using the jack.

Do not place the jack under a part of the bar that is not horizontal as it may slip.

Slide the silentbloc out of its retaining plate.
    • Raise the stabilizer bar using the jack.

    • Do not place the jack under a part of the bar that is not horizontal as it may slip.

    • Slide the silentbloc out of its retaining plate.

  4. 
To remove the silentbloc, simply pull on it.
    • To remove the silentbloc, simply pull on it.

  5. 
Reassembly is carried out in reverse order.
    • Reassembly is carried out in reverse order.

Finish Line

4 other people completed this guide.

laurent.immo13003

Member since: 03/03/2016

12,942 Reputation

155 Guides authored

3 Comments

I'm asking for a reassembly tutorial because it looks good on paper but in reality a new Silent bloc is bigger so I don't think that reassembly is done just in the opposite direction unfortunately, two days that I've been there and nothing to do no room to pass a serious tool to force on the buffer, I'm on the verge of putting the old one back.

Or send everything to the scrapyard.

rudy.cyrille - Reply

Good morning,

Have you found a solution?

I have the same problem as you, impossible to reassemble the new one, not enough force to compress/length of the screw too short...

Thank you very much !

rem0219 -

simple et efficace, les photos sont très précises

Georges Mesnard - Reply

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 18

Past 30 Days: 109

All Time: 9,621