Logo l'atelier Oscaro, la mécanique à portée de clic Logo Oscaro

Auris oil change and filter replacement

Written By: dlychar (and 2 other contributors)
  • Comments: 7
  • Favorites: 0
  • Completions: 2

Difficulty

Moderate

Steps

11

Time Required

00:45:00

Sections

1

Flags

1

Ce tutoriel a été créé par la communauté

Ce tutoriel a été créé par la communauté

User contributed

Introduction

Warm up the engine before draining

  1. Edit

  2. Remove the two clips to access the cap and oil filter Remove the two clips to access the cap and oil filter Remove the two clips to access the cap and oil filter

    • Remove the two clips to access the cap and oil filter

    Edit

  3. Place the drain pan under the car Unscrew the drain plug using the 15 mm flat wrench.

    • Place the drain pan under the car

    • Unscrew the drain plug using the 15 mm flat wrench.

    Edit

  4. Remove the oil filter using the filter wrench Remove the oil filter using the filter wrench Remove the oil filter using the filter wrench

    • Remove the oil filter using the filter wrench

    Edit

  5. Remove the old filter Remove the old filter

    • Remove the old filter

    Edit

  6. Check the correspondence between the old and new oil filters

    • Check the correspondence between the old and new oil filters

    Edit

  7. Replace the seal on the filter holder 10 mm from the shoulder, it must be placed in the groove provided for this purpose, do not forget to oil the seal. Install the new filter

    • Replace the seal on the filter holder 10 mm from the shoulder, it must be placed in the groove provided for this purpose, do not forget to oil the seal.

    • Install the new filter

    Edit

  8. Reinstall the oil filter Tighten the filter holder by hand

    • Reinstall the oil filter

    • Tighten the filter holder by hand

    Edit

  9. Replace the drain plug Tighten it using the 15 key

    • Replace the drain plug

    • Tighten it using the 15 key

    Edit

  10. Replace the cover Put the two clips back

    • Replace the cover

    • Put the two clips back

    Edit

  11. Put the vehicle back on the ground Pour the oil recommended by the manufacturer into the engine through the filler hole. Check the oil level with the dipstick

    • Put the vehicle back on the ground

    • Pour the oil recommended by the manufacturer into the engine through the filler hole.

    • Check the oil level with the dipstick

    • BE CAREFUL NOT TO EXCEED THE MAXIMUM LEVEL

    • Replace the dipstick and cap then start the engine to fill the oil filter

    • Check the oil level again with the dipstick

    Edit
Finish Line

2 other people completed this guide.

Author

with 2 other contributors

dlychar

Member since: 10/09/2017

10,314 Reputation

70 Guides authored

5 Comments

very good explanations, if I had a problem, it was to remove the oil filter cap due to not having the right key.

domi_812 - Reply

Thank you for the simple and effective tutorial.

apocalypse95110 - Reply

Thank you, very well explained. On the other hand, I have a phase 2 and to unscrew the drain plug, you need a 14 key.

STEPHANE CHARPENTIER - Reply

Thank you very much for this tutorial, it is very well explained.

jimmy Macquet - Reply

Thank you, very well explained and well documented

Jean-Yves Desloges - Reply

Add Comment

View Statistics:

Past 24 Hours: 5

Past 7 Days: 23

Past 30 Days: 91

All Time: 14,018

Oscaro.com   © 2024 Oscaro.com Tous droits reservés.