Introduction
This tutorial shows you the steps to change the ABS sensor of a rear wheel of your BMW. The model presented is a 330d E91 phase 1.
-
-
-
This step is not mandatory if you have a bridge or a pit, however it will make your work much easier.
-
-
-
Remove the 4 screws using an 8mm socket.
-
Remove the 4 nuts using a 10mm socket.
-
Clear the mudguard.
-
You don't have to remove the mudguard completely, just pry it loose enough to access the sensor connection.
-
-
-
Locate the connection.
-
Press the small square and push it outwards.
-
-
-
There are 2 hooks that hold the sensor in place.
-
Pull the hook outwards and then remove the sensor.
-
-
-
Using a 5mm Allen key, remove the screw.
-
Clean the sensor face and bore and coat with grease.
-
-
-
Reassembly is carried out in reverse order.
-
Compare the new sensor with the one you just removed to make sure they are the same length.
-
Cancel: I did not complete this guide.
3 other people completed this guide.