Skip to main content
  1. 
Securing the vehicle: removing and refitting the wheel
  2. 
It starts from the housing fixed on the chassis and goes to the rocket.

It starts from the housing fixed on the chassis and goes to the rocket.
    • It starts from the housing fixed on the chassis and goes to the rocket.

  3. 
Pull both staples.

Remove the connector by pulling on it.
    • Pull both staples.

    • Remove the connector by pulling on it.

  4. 
Pull to release the cable.

Pull to release the cable.
    • Pull to release the cable.

  5. 
Press the small square and then pull it to disconnect the sensor.

Press the small square and then pull it to disconnect the sensor.
    • Press the small square and then pull it to disconnect the sensor.

  6. 
Remove the screw using a 5mm Allen key.

Pull the sensor out.

Clean the bore with a rag and then coat it with Staburags NBU 12/K grease.
    • Remove the screw using a 5mm Allen key.

    • Pull the sensor out.

    • Clean the bore with a rag and then coat it with Staburags NBU 12/K grease.

  7. 
Reassembly is carried out in reverse order.
    • Reassembly is carried out in reverse order.

Finish Line

2 other people completed this guide.

laurent.immo13003

Member since: 03/03/2016

12,942 Reputation

155 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 7

Past 30 Days: 34

All Time: 1,565